2-channel DC motor output stage 48 V DC, 3.5 A EJ7342

EJ7342 | 2-channel DC motor output stage 48 V DC, 3.5 A

The EJ7342 EtherCAT plug-in module enables direct operation of two DC motors. It is galvanically isolated from the E-bus. The speed or position is specified by the automation device via a 16 bit value. Connection of an incremental encoder enables a simple servo axis to be realised. The output stage is protected against overload and short circuit, the common thermal overload warning applies to both output stages together. The EJ7342 has two channels that indicate their signal state via light emitting diodes. The LEDs enable quick local diagnosis.

Technical data EJ7342
Technology compact drive technology
Connection method direct motor connection
Number of inputs 1 x end position, 1 x encoder per channel
Load type DC brush motor, inductive
Number of channels 2
Number of outputs 1 x DC motor per channel
Supply voltage electronics 24 V DC (via signal distribution board)
Supply voltage power 8…48 V DC (via distribution board)
Output current max. 3.5 A per channel
PWM clock frequency 32 kHz with 180° phase shift each
Duty factor 0…100 % (voltage-controlled)
Resolution max. 10 bit current, 16 bit speed
Encoder input signal 5…24 V DC, typ. 5 mA, single-ended
Input frequency max. 400,000 increments/s (with 4-fold evaluation)
Auxiliary power current typ. 45 mA (via distribution board)
Current consumption E-bus typ. 160 mA
Distributed clocks yes
Special features travel distance control, encoder input
Electrical isolation 500 V (E-bus/field potential)
Weight approx. 50 g
Operating/storage temperature 0…+55 °C/-25…+85 °C
Relative humidity 95 %, no condensation
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Protect. class/installation pos. IP 20/see documentation
Approvals/markings CE, UL